Infinite Torture Cube v2 #3DPrinting #3DThursday

from Infinite Torture Cube v2 #3DPrinting #3DThursday
by Jessie Mae

Infinite Torture Cube v2 by z0333 Thingiverse

z0333 shared this project on Thingiverse!

This one is not for the faint hearted.
The clearance between the cubes is only 0.1mm.
I don’t own a fancy high end printer. Just a simple I3.
Print SLLLOOOOOWWWW and reduce 3-5% of your normal extrusion rate.

Good Luck!

I’ve added a test link so you’ll be able to tune your print settings before the real thing.
This is one of the more challenging parts within the model (to print and clean).
The connection link should face up.
Work with the direction of the hinges. Twist so the top sides of the cubes to face each other. The leg of the inner support will snap when you’ll free the cubes.
The pyramid that support the link from below is hollow. Use a wire cutter to cut it tip. Insert the cutter to the hole in order to firmly grasp the pyramid from the side, and twist to free it from the link.

Download files here:

Every Thursday is #3dthursday here at Adafruit! The DIY 3D printing community has passion and dedication for making solid objects from digital models. Recently, we have noticed electronics projects integrated with 3D printed enclosures, brackets, and sculptures, so each Thursday we celebrate and highlight these bold pioneers!

Have you considered building a 3D project around an Arduino or other microcontroller? How about printing a bracket to mount your Raspberry Pi to the back of your HD monitor? And don’t forget the countless LED projects that are possible when you are modeling your projects in 3D!

Original article: Infinite Torture Cube v2 #3DPrinting #3DThursday