NEW PRODUCT – STEMMA Wired Tactile Push-Button Pack – 5 Color Pack




from NEW PRODUCT – STEMMA Wired Tactile Push-Button Pack – 5 Color Pack
by Angelica

4431 demo 01 ORIG 2019 12

NEW PRODUCT – STEMMA Wired Tactile Push-Button Pack – 5 Color Pack


Little clicky switches are standard input “buttons” on electronic projects. These are just like our Colorful Round Tactile Button Switch Assortment, but already assembled onto a PCB – they even have a pull-up resistor installed! The pins are normally open (disconnected) and when the button is pressed they are momentarily closed.

Each button comes with a candy-colored round cap snapped on. You get one of each color– blue, white, yellow, red, and black.

4431 kit ORIG 2019 12

4431 top ORIG 2019 12

Best of all, each button board comes with a JST-PH 2mm connector and a matching  JST PH 3-Pin to Male Header Cables – 200mm, so wiring up is a cinch. Simply plug the cable in, then use the black wire to connect to your microcontroller/microcomputer ground, white wire to the input signal pin and the red wire to your power pin (3V or 5V) if you want to have the pull-up resistor activated.

If you want to connect to something with alligator clips use our STEMMA to Gator cable. To connect to something with a STEMMA 3-pin connector already, use this cable.

Works great with any device that wants a switch – Arduino, CircuitPython, Raspberry Pi, DIY builds…etc!

4431 quarter ORIG 2019 12

In stock and shipping now!





Original article: NEW PRODUCT – STEMMA Wired Tactile Push-Button Pack – 5 Color Pack
Author: