from New Products 8/14/2019 Featuring Adafruit MONSTER M4SK! @adafruit #adafruit
We’ve got the New nEw NEW for you right here:
NEW PRODUCTS THIS WEEK
Assembled DC Motor + Stepper FeatherWing Add-on
A Feather board without ambition is a Feather board without FeatherWings! This is the Fully assembled (with headers) DC Motor + Stepper FeatherWing which will let you use 2 x bi-polar stepper motors or 4 x brushed DC motors (or 1 stepper and 2 DC motors). Using our Feather Stacking Headers or Feather Female Headers you can connect a FeatherWing on top or bottom of your Feather board and let the board take flight!
USB Li-Ion Power Bank with 2 x 5V Outputs @ 2.1A – 5000mAh
Here’s a hand-held-size rechargeable battery pack for your Raspberry Pi (or Metro, or anything else that uses 5V!). This pack is intended for providing a lot of power to a smartphone, tablet, etc, but we found it does a really good job of powering other miniature computers and micro-controllers. If you want even more power, we have a 10,000mAh power pack with two USB ports that can provide up to 2A!
Micro Servo with 3-pin JST Cable – STEMMA Connector Compatible
This tiny little servo can rotate approximately 180 degrees (90 in each direction), and works just like the standard kinds you’re used to but smaller. You can use any servo code, hardware or library to control these servos. Good for beginners who want to make stuff move without building a motor controller with feedback & gear box, especially since it will fit in small places. Of course, it’s not nearly as strong as a standard servo. Works great with the Motor Shield for Arduino, or by just wiring up with the Servo library. Comes with a few horns and hardware.
SMT RGB 5050 LED – 10 pack
These surface-mount LEDs are an easy way to add a lot of colorful dots to your project. They’re similar to the ones in our analog RGB LED strip, same size and shape. They are half a centimeter on a side, which makes them small but not so small that they are impossible to hand solder. There are three LEDs inside, red green and blue and because they are so close together, they mix very nicely, without the need for a diffuser. The LED is also insanely bright, at an eyeball-blistering 2000mcd.
Adafruit ATECC608 Breakout Board – STEMMA QT / Qwiic
You’ve got secrets, and you want to keep them safe? Most microcontrollers are not designed to protect against snoopers, but a crypto-authentication chip can be used to lock away private keys securely. Once the private key is saved inside, it can’t be read out, all you can do is send it challenge-response queries. That means that even if someone gets hold of your hardware and can read back the firmware, they wont be able to extract the secret!
JST SH 9-Pin Cable – 100mm long
This 9-pin cable is just about 100mm / 4″ long and fitted with JST-SH female connectors on both ends. Compared with chunkier JST-PH these are 1mm pitch instead of 2mm, but still have a nice latching feel and are easy to insert and remove.
Adafruit MONSTER M4SK – Two Eyes are Better Than One!
Peep dis! Have you always wanted to have another pair of eyes on the back of your head? Or outfit your costume with big beautiful orbs? The MONSTER M4SK is like the Hallowing but twice as good, with two gorgeous 240×240 pixel IPS TFT displays, driven by a 120MHZ Cortex M4 processor that can pump out those pixels super fast. You’ll get the same quality display as our Raspberry Pi Eyes kit but without needing to tote around a full Linux computer
New Products 8/14/2019 Featuring Adafruit MONSTER M4SK!
Visit www.adafruit.com/new for more info.