Raspberry Pi3 IR Camera Wide-angle waterproof housing #3DPrinting #3DThursday




from Raspberry Pi3 IR Camera Wide-angle waterproof housing #3DPrinting #3DThursday
by Jessie Mae

E3764b34e7da46aa1a2d36657624f7b1 preview featured
bujna94 shared this project on Thingiverse!

Hi, I designed this housing for:

MakerHawk Raspberry Pi3 Camera IR Fisheye Wide-angle 175 Degree 5MP OV5647.

Link to Amazon – https://amzn.to/2G10jXE

I was printing it with PETG 100% infill, but PLA or ABS will be fine too. (PLA is not recommended for outdoor use). Gaskets I print with TPU 100% infill again.

My printer is Ender 3 & layer height was 0.3mm.

The reason why the camera lens is not covered with plexiglass is night vision. If I just cover the whole camera with plexiglass, IR lights will reflect and you will be not able to see almost anything.

See more!


649-1
Every Thursday is #3dthursday here at Adafruit! The DIY 3D printing community has passion and dedication for making solid objects from digital models. Recently, we have noticed electronics projects integrated with 3D printed enclosures, brackets, and sculptures, so each Thursday we celebrate and highlight these bold pioneers!

Have you considered building a 3D project around an Arduino or other microcontroller? How about printing a bracket to mount your Raspberry Pi to the back of your HD monitor? And don’t forget the countless LED projects that are possible when you are modeling your projects in 3D!





Original article: Raspberry Pi3 IR Camera Wide-angle waterproof housing #3DPrinting #3DThursday
Author: