Pumpkin Spider Robot

from Pumpkin Spider Robot
by Takara

via rhattie on Thingiverse

A quick and dirty edit of MegaWillBot’s spider pumpkin to allow for the installation of LED lighting. The pumpkin section of the head has also been separated to allow for printing in a separate material.

Note that this is at 150% scale! You’ll need to scale the remaining parts from the original design to match this. This will also affect the tolerances of the ball joints, so if you don’t plan on glueing them like I did, you’ll want to adjust your scaling or XY offset on the legs to compensate. Also, as you might expect, all the wires inside make it more or less impossible to actually fold this thing up, so treat it as more of a display item than a toy.

See more!

Original article: Pumpkin Spider Robot
Author: