NEW PRODUCT – Pimoroni HyperPixel 4.0″ High-Res Display for Raspberry Pi – Non-Touch

from NEW PRODUCT – Pimoroni HyperPixel 4.0″ High-Res Display for Raspberry Pi – Non-Touch
by Angelica

3932 top lit demo ORIG 2018 09

NEW PRODUCT – Pimoroni HyperPixel 4.0″ High-Res Display for Raspberry Pi – Non-Touch


Pimoroni’s HyperPixel features a 4.0″ display with 800×480 18-bit color pixels. The plate uses the high speed DPI interface on the Pi and can use the mini display as a console, X window port, displaying images or video, etc. Best of all, it plugs right in on top – So easy!

The DPI interface is super fast, and has speed-optimizations just like HDMI, but it uses just about every pin on the Pi so it is a challenge to use this and also connect sensors, add-ons, device, etc to the Pi. You should stick to devices that interface with USB rather than the GPIO header.

3932 iso ORIG 2018 09

The HyperPixel 4.0″ is designed to fit nicely onto the Raspberry Pi Zero, Pi 3, Pi 2 or Model A+ / B+ (any Pi with a 2×20 connector). Not for use with the old Pi 1 with 2×13 connectorIf you’d like to use a 3.5″ display with the original Pi A or Pi B, check out the SPI-based PiTFT 3.5″

Everything comes fully assembled, so there’s no soldering required! The display secures to the HyperPixel PCB via a neat little flush-mounting FPC cable. Just pop HyperPixel on your Pi and run the installer to get set up!

3932 kit 02 ORIG 2018 09

Works with any 40-pin version of the Pi, including Pi Zero and Pi Zero W. If you’re using it with a larger Pi like the B+, 2, or 3, then use the extra 40-pin header that’s included to boost it up to the required height. If you’re using a Zero or Zero W then just pop it straight onto the GPI.

Features

  • High-speed DPI interface
  • 4.0″ IPS (wide viewing angle, 160°) display (86.4×51.8mm)
  • 800×480 pixels (~235 PPI)
  • 18-bit color (262,144 colors) (that’s 262,144 colors! yowza!)
  • 60 FPS frame rate
  • Contrast ratio: 500:1
  • 40-pin female header included to boost height for Pi B+, 2, 3, 3 B+
  • Standoffs included to securely attach to your Pi
  • Compatible with Raspberry Pi 3 B+32B+A+Zero, and Zero W
  • One-line installer

Please note: when installing HyperPixel onto your Pi, make sure not to press down on the screen surface. Hold the board by its edges and wiggle it to the extended header (or GPIO header).

We also carry its capacitive touch “cousin”!

3932 quarter ORIG 2018 09

In stock and shipping now!

Original article: NEW PRODUCT – Pimoroni HyperPixel 4.0″ High-Res Display for Raspberry Pi – Non-Touch
Author: